Hi @waterwingz, would you mind taking a look at the attached log? When the Shot Interval is set to [Fast], the Shot Sync LED stays ON a little longer than a second. In [Burst] mode, the LED drops under a second; but it turns ON twice between shots. TIA!
It's been a while since I've looked at the script's
Fast &
Burst modes.
The behavior shown in your log is strange - when shooting in
Burst mode it fails to reach the
hook_shoot.is_ready point within 2 seconds of pressing
shoot_full on every second shot. It's also taking up to five seconds between shots when it should be shooting in under a second.
This might cause what seems like the extra LED "on" pulses you are seeing between shots.
Why it does that I don't know. I have not seen this behavior before on any other cameras so it does make me wonder if the shoot hooks are correctly located in your port?
I take a look at it again later today or tomorrow.
