SX170 porting - page 8 - DryOS Development - CHDK Forum

SX170 porting

  • 266 Replies
  • 99159 Views
Re: SX170 porting
« Reply #70 on: 20 / August / 2014, 22:56:32 »
Advertisements
Thanks BinMaster

I have attached the generated software.
Please try!

Re: SX170 porting
« Reply #71 on: 20 / August / 2014, 23:14:20 »
I have already tried but without results, the camera is dead.
CardTricks144 use tool, 4GB FAT16 format.

Re: SX170 porting
« Reply #72 on: 20 / August / 2014, 23:23:54 »
the camera does not respond when I load the boot sd.

Re: SX170 porting
« Reply #73 on: 21 / August / 2014, 05:59:07 »
Janeouri Is rhe same firmware you are using in your side?

Re: SX170 porting
« Reply #74 on: 21 / August / 2014, 06:42:01 »
Janeoyuri is the
lenght of my firmware equal to yours?

Re: SX170 porting
« Reply #75 on: 21 / August / 2014, 07:23:38 »
Can anybody send me a working firmware?

Re: SX170 porting
« Reply #76 on: 21 / August / 2014, 07:33:25 »
if it is the same, it says waterwingz about it.
garden thank you very much for the great job you did.
« Last Edit: 21 / August / 2014, 07:37:11 by BinMaster »

Re: SX170 porting
« Reply #77 on: 21 / August / 2014, 09:51:33 »
janeoyuri

Can you send me the firmware you tested so that I can try to figure out what is hapeen over here?
Thanks


Re: SX170 porting
« Reply #79 on: 21 / August / 2014, 10:27:59 »
Hi BinMaster
The version you sent me is showing the CHDK splash window, shows a message "Test version expired". I can start a limited menu . At least it booted. What I notice is that firmware version is 100A. I am using 101A.

I need 101A to compare with the frmware I generated.

Thanks

 

Related Topics


SimplePortal © 2008-2014, SimplePortal