Holy smokes, some of you guys on these threads are just so frickin smart. I have a very basic question that will probably bore you...
I'm trying to take some high speed photos. So I set the override shutter speed to 1/100k and the value factor to 1. Enum type = Ev Step. I haven't changed anything else. Then I toggle out of the <alt> mode so I can start taking photos.
In the top left part of the screen it reads TV:1/100k. But when I push the shutter half way down, the bottom of the screen reads 1/3200 for the shutter speed. I'm assuming this is because this is the highest speed the camera can normally do and it doesn't have the internal software to read 1/100k. Or am I doing something wrong?
When I review the properties of the photo after it's been taken, it lists a shutter speed of 1/3200. Is there any way to tell what the actual shutter speed it took the photo at?
thanks