CHDK SX260 RAW Problems - General Help and Assistance on using CHDK stable releases - CHDK Forum
« previous next »
Pages: [1]   Go Down

CHDK SX260 RAW Problems

  • 3 Replies
  • 2950 Views
*

Offline exo

  • *
  • 2
CHDK SX260 RAW Problems
« on: 08 / August / 2015, 07:01:17 »
Advertisements
Hi, hoping someone can point me in the right direction..

I'm using an SX260 with CHDK and 3DR_EAI_SX260.lua (based on KAP 3.1)

My problem is that each time the script auto loads on startup the 'Save RAW' check-box is becoming un-checked. If I disable the script it remains checked during a power-cycle.

Any ideas?

Thanks.
Logged
*

Offline srsa_4c

  • ******
  • 4451
Re: CHDK SX260 RAW Problems
« Reply #1 on: 08 / August / 2015, 07:20:54 »
Quote from: exo on 08 / August / 2015, 07:01:17
I'm using an SX260 with CHDK and 3DR_EAI_SX260.lua (based on KAP 3.1)

My problem is that each time the script auto loads on startup the 'Save RAW' check-box is becoming un-checked.
If you don't want the script to change your RAW setting, remove the line that says
Code: [Select]
set_config_value(2,0) --Save raw: off
Logged
*

Offline exo

  • *
  • 2
Re: CHDK SX260 RAW Problems
« Reply #2 on: 08 / August / 2015, 07:29:30 »
Sorted, thanks very much srsa_4c
Logged
*

Offline waterwingz

  • ******
  • 12140
    • Waterwingz
Re: CHDK SX260 RAW Problems
« Reply #3 on: 08 / August / 2015, 09:50:23 »
Quote from: srsa_4c on 08 / August / 2015, 07:20:54
Quote from: exo on 08 / August / 2015, 07:01:17
I'm using an SX260 with CHDK and  (based on KAP 3.1)

My problem is that each time the script auto loads on startup the 'Save RAW' check-box is becoming un-checked.
If you don't want the script to change your RAW setting, remove the line that says
Code: [Select]
set_config_value(2,0) --Save raw: off

Incidentally, while 3DR_EAI_SX260.lua is almost identical to an older version of kap_uav.lua there are a few small setup changes.  Including the automatic disabling of RAW.   I can only assume this was done because should you accidentally enable RAW when you don't want it,  you will fill up your SD card much more quickly and you will slow down your fastest shooting rate by a factor of about 2 .


« Last Edit: 08 / August / 2015, 09:51:56 by waterwingz »
Logged
Ported :   A1200    SD940   G10    Powershot N    G16
Pages: [1]   Go Up
« previous next »
 

Related Topics


SimplePortal © 2008-2014, SimplePortal