It's modified LP-E12 battery without thermistor contact (LP-E12 is slightly shorter).
but rollback to previous fw is still available...
00034020: UI:ShootSeqToUI:0x00003157:adr:0xfc2a50cb,Para:-6433566900034030: UI:DSIC:e3,000034030: UI:VTMLock00034070: UI:VTMUnLock
Can somebody with this camera check whether CHDK exposure overrides remain effective after the shutter is held halfway down for a few seconds?On the M10, they are getting overridden by the Canon firmware in all shooting modes except M. That means, when CHDK overrides are set, they are reflected on the Canon overlay for a few moments after a half press, then the exposure parameters return to Canon calculated values.
When that happens, I get these entries in the camera log:
I go on the M3 to AV Mode. ISO100, Av=3.5 and the Camera measure 1/6s.I got to Enhanced Photo Operation => Override Tv ‘ShrtExp’ and set it to 0.001s.Now the Canon menu shows Tv=1/1000 when I go to half shutter press. The value is not changing. I did it for 15s.I that what you mean?
Update:I can reproduce it. But it is only happening, when the cam can’t focus (when I got the red square). When the cam focus correct, it is not changing.
ROMLOG.LOG?This Shows only older stuff..
I had the cam set to MF when I noticed the override issue.
Normally the aperture does not change between the shoots in rawopint (which is at least my other cameras so).However, with the M3, the shutter is opened and closed with each shot. This is, however, only in single mode. This does not happen in the continuous mode. In continuous mode the aperture remains fixed in the set position.
Yes, the same happens when I go to MF. Does that means rawopint will not work in MF Mode or with manual lens?
Started by cyrustam
DSLR Hack development
Started by udo
« 1 2 3 4 »
Hotwire! Hardware Mods, Accessories and Insights
Started by srsa_4c
« 1 2 ... 19 20 »
Started by leGorb
General Discussion and Assistance
Started by cedricb