SD800IS histogram position too low - AllBest's Builds - CHDK Forum
« previous next »
Pages: [1]   Go Down

SD800IS histogram position too low

  • 3 Replies
  • 4063 Views
*

Offline mrblack51

  • *
  • 27
SD800IS histogram position too low
« on: 06 / May / 2008, 23:59:46 »
Advertisements
I am running the current trunk build (48 I believe) and the histogram is showing too low, such that when you have "R G B" set the blue is cut off the screen. Where should I check to make sure that the display offset for rendering the histogram is correct?

thanks
Logged
*

Offline vine

  • ***
  • 124
  • A560
    • my chdk page
Re: SD800IS histogram position too low
« Reply #1 on: 07 / May / 2008, 02:58:55 »
You can completely change to layout of your OSD using the layout editor.
CHDK firmware usage - CHDK Wiki
Logged
my photo map

my chdk page with tutorials, scripts and more

>> finally back from vacation (was a bit longer than intended) <<
*

Offline PS

  • ***
  • 157
  • A610 1.00f
Re: SD800IS histogram position too low
« Reply #2 on: 07 / May / 2008, 11:05:22 »
But what was the point of making it so low by default? You just have one more thing to set up.
Logged
*

Offline PhyrePhoX

  • *****
  • 2254
  • make RAW not WAR
    • PhyreWorX
Re: SD800IS histogram position too low
« Reply #3 on: 07 / May / 2008, 11:08:11 »
There was only one type of histogram in the beginning,thus the low default pos.
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics


SimplePortal © 2008-2014, SimplePortal