Is there a easy way to find out failed cameras ?

cdg

Is there a easy way to find out failed cameras ?

« on: 08 / May / 2017, 07:01:43 »

Advertisements

Hello:
I have some cameras,sometime one or two of them failed like lose connection or “WARNING:000: send **** cmd failed : I/O error”,then i can't control all of them，i need to find out which one is the problem by test all of them one by one，or shut down all of the cameras and turn on again.
So is there a easy way to find out failed cameras ? or just [/size]ignore the failed cameras and control the rest then i could find out which one is the problem.[/color]

Logged

srsa_4c

4447

Re: Is there a easy way to find out failed cameras ?

« Reply #1 on: 09 / May / 2017, 13:40:56 »

Quote from: cdg on 08 / May / 2017, 07:01:43

So is there a easy way to find out failed cameras ?

I'm only answering because no-one else did. There was a similar discussion in the multi-camera thread. I came up with this addition to multicam.lua. The lines can be copy&pasted right above the following in multicam.lua:

Code: [Select]

--[[
return an iterator over selected cams
]]

I have no idea whether it is helpful or not. You can also read the preceding and followup posts in that thread.

Logged

Menu jumping/flickering on M10?

cdg

Re: Is there a easy way to find out failed cameras ?

« Reply #2 on: 10 / May / 2017, 19:37:47 »

Quote from: srsa_4c on 09 / May / 2017, 13:40:56

Quote from: cdg on 08 / May / 2017, 07:01:43
So is there a easy way to find out failed cameras ?
I'm only answering because no-one else did. There was a similar discussion in the multi-camera thread. I came up with this addition to multicam.lua. The lines can be copy&pasted right above the following in multicam.lua:
Code: [Select]
--[[ return an iterator over selected cams ]]I have no idea whether it is helpful or not. You can also read the preceding and followup posts in that thread.

Thank you very much ！
I am going to try it ！！！

Logged