.... a diybookscanner.....if i use two old tv and have video and usb remote at the same time.
....i have stuck and need some help.....
.....i have cut wires S(Sheild ()) ,5,6,7,8,9,10,11....
....i connect the camera to extusb and usb-b to extusb and captured a photo....
"...how can i conncect the wires to have (Live View) Video...."
....i only want to use a single video cable. i dont need audio....
i want the easiest connection . dont care if i have only liveview and usb remote
Just guessing about this (EXT-USB-B 11pin Connector) stuff below:-
Ref :- HTC ExtUSB 11 Pin USB Connector with a Breakout (PCB)
here (but now retired) https://www.sparkfun.com/products/retired/9167
or it was also available on ebay .
• 1: USB VCC +5v (= Ok)
• 2: USB Data - (= Ok)
• 3: USB Data + (= Ok)
• 4: N / C (= Ok)
• 5: USB GND (= Ok)
• 6: Left Audio +
• 7: Labeled “AG”
• 8: Audio - (GND) Labeled “CK”
• 9: Switch (Talk) Labeled “OT”
• 10: Right Audio +
• 11: Mic +
• 12: Chassis Ground (GND/Sheild)
The correct pin outs (for, Live View, Video (
)) are here
"...Here are the pinouts for the Canon AVC-DC400ST Video/Audio cable. and the colours on the splitter to connect them to..."
11 GRND (vid/aud -) – (Red wire on our connector.)
10 Composite Video + (Purple wire on our connector.)
9 Left (white) Audio + (Orange wire on our connector.)
8 Right (red) Audio + (Yellow wire on our connector.)
7 N/C -
6 GRND (vid/aud - ) Video out enable. ( If connected to blue wire on our connector, video is output via cable.
May put switch to change between LCD and video output)
On the standard Canon audio/video cable, pins 6 and 11 (red and blue) seem to be tied together.
This causes the camera to start outputting video and audio any time the cable is plugged in.
You can put a switch between pin 6 (blue wire) and ground and be able to switch from video output via cable to LCD display without unplugging the cable.
Edit #1 "11_pin_HTC_ExtUSB_jack"
Ref 1:- http://connector.pinouts.ru/11_pin_HTC_ExtUSB_jack/
Ref 2:- http://pinouts.ru/CellularPhones-A-N/htc_extUSB_pinout.shtml