SX50 crashes: Subject Distance Override / Distance Bracketing / ND Filter Option

Advertisements

Hi I would like to report three conditions that reproducibly lead to crashing of CHDK on my Canon SX50, Firmware 1C.

1. Setting Distance Override to any value (100 .. infinite) and setting the camera to manual focussing results in a crash after the shutter button is pressed. This is observed for CHDK versions 1.3.1, 1.4.1 and 1.5

2. Setting Distance Bracketing to any value and setting the camera to manual focussing results in a crash after the shutter is pressed and held. This is observed for CHDK versions 1.3.1, 1.4.1 and 1.5

3. Setting the the ND Filter Option to "In" now works since Firmware version 1.4.1. In 1.3.1 nothing happened despite the message that the ND Filter was in. However, when the shutter is half pressed, focussing only works correctly during the 1st attempt. If no photo is taken and the shutter is half-pressed again, the focussing light does not come on. If again no photo is taken and the shutter is half-pressed for a third time, the camera crashes, reproducibly.

Are there any updated CHDK distributions or alternative branches, etc. available that solve these issues ?

Thank you and best regards,
Klaas

Replies	Last post
Override Subject Distance on A470 Started by Sask View General Help and Assistance on using CHDK stable releases	0 Replies 2116 Views	by Sask View
SX160IS crashes with Override Subj. Distance Started by sequencer General Discussion and Assistance	0 Replies 1804 Views	by sequencer
Option for "Feet" in Subject distance override? Started by l_d_allan Feature Requests	0 Replies 2142 Views	by l_d_allan
Override Subject Distance, Set zoom Started by cdordoni General Discussion and Assistance	3 Replies 4805 Views	by cdordoni
Bracketing in continuous mode: subject distance Started by pigeonhill « 1 2 » General Help and Assistance on using CHDK stable releases	14 Replies 4779 Views	by pigeonhill

Subject / Started by

Replies

Last post