So, on G1x it’s a huge difference of current if I use Display off on Canon Menu. It looks like that I can do time-lapse when I switch display off before I start the script
This is the next measurement which I try to do… also with Display off on Canon
After you type rsint in the console, it waits for you to send a command in the same way that rawopint etc wait for the interval.rsint -cont will use continuous mode (if set on camera), otherwise it uses quick. Commands at the rsint prompt ares = shootl = shoot and quit (continuous mode can't quite without taking another shot)q = quit
WARNING: E:\CHDK\chdkptp-r723\lua\chdku.lua:1366: General Errorstack traceback: E:\CHDK\chdkptp-r723\lua\chdku.lua:1366: in function 'capture_get_data' E:\CHDK\chdkptp-r723\lua\rsint.lua:135: in function <E:\CHDK\chdkptp-r723\lua\rsint.lua:86> [C]: in function 'xpcall' E:\CHDK\chdkptp-r723\lua\rsint.lua:259: in function <E:\CHDK\chdkptp-r723\lua\rsint.lua:152> (...tail calls...) [C]: in function 'xpcall' E:\CHDK\chdkptp-r723\lua\cli.lua:285: in function 'execute' E:\CHDK\chdkptp-r723\lua\cli.lua:400: in function 'run' E:\CHDK\chdkptp-r723\lua\gui.lua:744: in function <E:\CHDK\chdkptp-r723\lua\gui.lua:744>ERROR: rsint failed
Not sure if I made it correct. Can I use 's' only ones?
After the second shoot I got the following warning (in cont and quick)Code: [Select]WARNING: E:\CHDK\chdkptp-r723\lua\chdku.lua:1366: General Errorstack traceback: E:\CHDK\chdkptp-r723\lua\chdku.lua:1366: in function 'capture_get_data'
WARNING: E:\CHDK\chdkptp-r723\lua\chdku.lua:1366: General Errorstack traceback: E:\CHDK\chdkptp-r723\lua\chdku.lua:1366: in function 'capture_get_data'
I made a second measurement with rawopint with an interval of 25s. Between the shoots, independent if I use cont or quick, I measured always 0,3A. Also, when I switch off display with Canon bottom, between the shoots I have always 0,3A.Only when I use a simple interval script with single shoots (with Canon Disp Off), I got the 0,15A between the shoots. I measured also the current of a shoot with 30s. The current was 0,28A while shooting and 0,23A with Canon Disp Off.
Did you have canon raw+jpeg enabled?
That’s it… thanks … only JPG works fine…
Can I increase the size of the live view in chdkptp?
Started by streetbikertje
Started by blongo
General Help and Assistance on using CHDK stable releases
Started by axman
Started by reyalp
Completed and Working Scripts