Opinions on the ELPH 180? - General Help and Assistance on using CHDK stable releases - CHDK Forum
« previous next »
Pages: [1]   Go Down

Opinions on the ELPH 180?

  • 3 Replies
  • 3333 Views
*

Offline jdstech

  • **
  • 52
Opinions on the ELPH 180?
« on: 24 / April / 2018, 12:53:11 »
Advertisements
So I'm thinking about upgrading my 3d scanner from a3400IS's to ELPH 180's, are they any good? Do they get along well with chdk?
Logged
*

Online reyalp

  • ******
  • 14139
Re: Opinions on the ELPH 180?
« Reply #1 on: 24 / April / 2018, 13:23:03 »
There's an at least partially functional port in https://chdk.setepontos.com/index.php?topic=13063.160

It would be nice to get that port finished and in the auto build, but I'm not clear what the status.
Logged
Don't forget what the H stands for.
*

Offline cdordoni

  • *
  • 19
Re: Opinions on the ELPH 180?
« Reply #2 on: 24 / April / 2018, 16:32:38 »
I was interested in the Elph180 but discovered there is a defect which required some units to be sent for a factory repair. The only way to determine if it has to be sent back is some code on the inside of the battery door. Additionally, only one version of the firmware is supported, and again its necessary to have the camera in hand to determine this.

Thanks to blackhole for providing the link below to the factory repair info another thread
https://www.usa.canon.com/internet/portal/us/home/support/product-advisories/detail/Service%20Notice%20PowerShot%20ELPH%20180
« Last Edit: 26 / April / 2018, 17:03:23 by cdordoni »
Logged
*

Offline cdordoni

  • *
  • 19
Re: Opinions on the ELPH 180?
« Reply #3 on: 27 / April / 2018, 10:54:44 »
reyalp offered the following info, thanks reyalp!
"FWIW, for people in the US, Canon's official refurbished store often has good prices, and cameras purchased there would almost certainly have the issue addressed."
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics


SimplePortal © 2008-2014, SimplePortal