Hi,
I've just purchased a SX620 HS with 100c firmware and trying to get CHDK to work. Getting some very interesting behaviour when taking a photo, it also takes a 3 second video and then shows the photo being taken. Really odd.
Version installed:
CHDK for sx620hs fw:100c PID:12995
build:1.5.1-6023_ALPHA date:Mon, 15 Nov 2021 00:58:14 +0100
I've done a clean setup/install and can recreate the issue on the very first photo as below:
Reset camera to default.
Format memory card.
Use stick to install CHDK, 32G SD card
Set card to read only
Insert card and push power button
Camera starts into play mode
Half press shutter button to open lens
Full press shutter button to take picture
Picture taken, shutter sound plays immediately
Screen comes up and says busy for a few seconds
Goes on as normal but when I view the picture there is a jpeg and mp4.
Each picture taken adds to the video, even if I restart the camera in the middle.
I've uploaded the video of 2 photos taken in the above scenario to youtube -
Any suggestions? Is there any debug logs I can look at to try and figure this out?
Thanks