S80 dump to start port - page 3 - Firmware Dumping - CHDK Forum
« previous next »
Pages: 1 2 [3]   Go Down

S80 dump to start port

  • 23 Replies
  • 19315 Views
*

Offline jemilambi

  • *
  • 4
Re: S80 dump to start port
« Reply #20 on: 17 / June / 2008, 04:41:23 »
Advertisements
Logged
*

Offline yujin

  • *
  • 15
Re: S80 dump to start port
« Reply #21 on: 05 / August / 2008, 05:05:30 »
Quote from: jemilambi on 17 / June / 2008, 04:41:23

Were you able to make a dump of the 1.00f firmware of your powershot?  If yes, which way did you do?  With blinker method?  Or with pure software method?


I used the pure software method to dump the firmware. FYI, my S80 has firmware ver 1.01b.
Logged
*

Offline etotore

  • *
  • 1
Re: S80 dump to start port
« Reply #22 on: 10 / August / 2008, 18:02:42 »
A620 and SD450 are relased from canon at almost the same time as S80..
Maybe we can learn something from these builds?

Comment I don't think it possible to run orginal bios from SD card, at all..
Maybe I'm wrong, but, also if U where right will not the firmware read from the rom address of original FW, the id?

:)
Logged
*

Offline powershots80

  • *
  • 26
Re: S80 dump to start port
« Reply #23 on: 25 / February / 2010, 19:36:12 »
Been trying to dump my PS s80 gm1.00H firmware to save a copy of it before I downgrade to gm1.00G in order to use the beta CHDK for my Canon PS S80. 

I've used Cardtricks to get the dump but when I use the clean function it just runs forever and last popup message says "Trimming 11800064 Trailing 00".  I don't find any output of a bin file at the designated folder either.

Has anyone else tried to do this with the PS S80 firmware GM1.00H?

I'm not even sure if I should bother worrying about the downgrade back to G since there is no CHDK for that version anyway.

Logged
Pages: 1 2 [3]   Go Up
« previous next »
 

Related Topics


SimplePortal © 2008-2014, SimplePortal