Opening it up is for another day though, preferably after testing ND.
Camera is set to foreign language and wants clock to be set, nothing reacts in PTP (up down etc.) and on camera no button presses show in the PTP UI overlay, palette is broken...
=post_levent_to_ui(4484)
So, are you interested in fixing the G11 enough for PTP so that I can configure and test it?
Sure. I'll split this into another thread, since I think it will mostly not be ND...
Palette is broken as shown, CHDK_PTP said something and I'm including the note in the screen grab
One thing you can check for ND support is whether propcase 194 reflects the ND state set in the canon UI. So, use the Canon menu to set ND out, do =return get_prop(194), set it in, get_prop again.
> =return get_prop(194)5:return:1> =return get_prop(194)6:return:0
1 is ND in 0 is ND out
=set_led(0,1)... check which led is on=set_led(0,0)=set_led(1,1)... etc
1) Turn on "Miscellaneous stuff->Debug->Show misc values". The 2nd and 3rd values are labeled AVB and VB. In rec mode, AVB should cycle in the range 0-2, and VB should be a long hex value like 0x40587700, also cycling. I don't need the specific values of VB, just want to know if it cycles values like that, probably all starting with 0x4.
2) Which LEDs are controlled by set_led(), likeCode: [Select]=set_led(0,1)... check which led is on=set_led(0,0)=set_led(1,1)... etcOnly 0-6 need to be checked.
=set_led(0,1) Upper LED adjacent to EVF on continuous=set_led(0,2) Upper LED adjacent to EVF blinks slow=set_led(0,3) Upper LED adjacent to EVF blinks fast=set_led(0,4) Upper LED adjacent to EVF blinks faster than 2, slower than 3=set_led(0,5) Upper LED adjacent to EVF blinks fast 4 or five times, then off=set_led(0,6) Upper LED adjacent to EVF blinks slow again=set_led(0,7) Upper LED adjacent to EVF on continuous
Thanks, what a nice thing to try Sunday night :-)Something caught me off guard. Not much worked while having the defunct display folded away. Once I realized that I should probably open it, things came together...
Don't know what you expect. I think there are 5 LEDs. 2 orange next to +/-EV and ISO dials, one in the power button, two adjacent to the EVF. Four are on when booting the camera. Only the lower one next to the EVF is not. With the command ony one LED reacts in various ways:Code: [Select]=set_led(0,1) Upper LED adjacent to EVF on continuous
=set_led(0,1) Upper LED adjacent to EVF on continuous
Do the UI colors look approximately OK?
I should have been clearer. The *first* parameter is the LED number (which should be tested from 0-6). The second value sets the state of the LED: 1 turns on (solid), 0 turns off, other values may blink, but I don't care about those.
Started by kxp General Help and Assistance on using CHDK stable releases
Started by pigeonhill General Help and Assistance on using CHDK stable releases
Started by toby LUA Scripting
Started by JvdP « 1 2 » General Discussion and Assistance
Started by axman General Help and Assistance on using CHDK stable releases