Multi-partition support for the TX1 - General Discussion and Assistance - CHDK Forum supplierdeeply

Multi-partition support for the TX1

  • 2 Replies
  • 1801 Views
Multi-partition support for the TX1
« on: 23 / May / 2008, 05:29:18 »
Advertisements
writing mount.c in assembly for each firmware is exhausting work


My friend is in China for one month starting next week, maybe he will have a lot of spare time.

He needs to create mount.c and change the following :-

camera.h,  \generic\wrappers.c,  \tx1\main.c,  \tx1\sub\xxx\mount.c     and stubs.

For mount.c, is it different to porting, where we mainly find the correcting addresses for functions or do we have to write new code ?

For video recording with the TX1 at high quality, will partitioning decrease performance ?


David

*

Offline ewavr

  • ****
  • 1057
  • A710IS
Re: Multi-partition support for the TX1
« Reply #1 on: 23 / May / 2008, 06:52:26 »
Now multipartition support for TX1 added to trunk.

For video recording with the TX1 at high quality, will partitioning decrease performance ?

Camera reads partition table only at startup. So, this is question about FAT16 and FAT32 performance on this camera, I don't know this...

Re: Multi-partition support for the TX1
« Reply #2 on: 23 / May / 2008, 08:54:12 »
Now multipartition support for TX1 added to trunk.


THANK YOU !

I will tell him straight away.

Maybe he will take his two TX1 cameras to China and test this.


David

 

Related Topics