Why isn't this script working? (PowerShot SX410 IS)

Quote from: Little9070 on 26 / August / 2022, 17:13:50

I'm trying to write a script to set the zoom speed to maximum while recording. (I don't mind the zooming noise.) But I can't get much farther than this. Any help would be appreciated. (And yes it is encoded as ANSI/ASCII)

As I mentioned in the other thread, the set_zoom_speed function only controls the speed used when you zoom using the set_zoom function. It does not affect the speed used in response to key presses.

So if you did

Code: [Select]

set_zoom_speed 100
set_zoom 100

It should zoom at full speed to zoom point 100.

However, if you want to manually zoom at high speed, this doesn't help. You might be tempted to try to write a script that calls set_zoom in response to key presses, but this wouldn't really work either, because you can only tell set_zoom to zoom to a particular point, rather than zooming until some event tells it to stop.

edit:
I should also mention that set_zoom_speed takes a value in percent (1-100), but for most cameras, there are only two or three speeds. So for max speed, you'd want 100, and for slow 1. A few very old cameras do support additional speeds.

Replies	Last post
Why oh why did Canon choose Quicktime format ? Started by Microfunguy « 1 2 » General Discussion and Assistance	16 Replies 12387 Views	by Microfunguy
Jpeg badpixel removal isn't working for me. Am I doing something wrong? Started by pickler General Help and Assistance on using CHDK stable releases	7 Replies 6646 Views	by waterwingz
SX410 1.00B & 100C fw dump Started by alvm Firmware Dumping	5 Replies 12865 Views	by fe50
SX410 IS porting thread Started by blackhole « 1 2 ... 8 9 » DryOS Development	86 Replies 70175 Views	by srsa_4c
Need some assistance with a (sort of) broken camera flash on an SX410 IS Started by Little9070 General Discussion and Assistance	7 Replies 2734 Views	by reyalp

Subject / Started by

Replies

Last post