SX110IS - howto start porting - page 54 - DryOS Development

danielv

3

Re: SX110IS - howto start porting

« Reply #530 on: 22 / November / 2009, 23:40:47 »

Advertisements

is a port of the curves to 12-bit under development at the moment? any word on current status, ETA? can i help? :-)

Logged

jng

6

Re: SX110IS - howto start porting

« Reply #531 on: 28 / November / 2009, 12:50:42 »

Logged

chdkj

140

Re: SX110IS - howto start porting

« Reply #532 on: 29 / November / 2009, 12:24:21 »

Quote from: jng on 28 / November / 2009, 12:50:42

Question: How to set custom camera profiles in Lightroom?

Put them into the camera profiles folder of Adobe Camera Raw (application data folder for "All Users"; for instance C:\Documents and Settings\All Users\AppData\Adobe\CameraRaw\CameraProfiles\Camera\Canon PowerShot SX110IS). Paths might be different at your setup.

Cheers.

Logged

sx110

danielv

3

Re: SX110IS - howto start porting

« Reply #533 on: 12 / December / 2009, 21:45:40 »

any word on development of curves for 12-bit sensors?

Logged

chdkj

140

Re: SX110IS - howto start porting

« Reply #534 on: 13 / December / 2009, 13:00:44 »

I don't track that. It's not a camera specific issue. You should search for in forum.

Logged

sx110

ntstatic

246

Re: SX110IS - howto start porting

« Reply #535 on: 25 / January / 2010, 09:38:55 »

Thank you !!! chdkj and everyone on the chdk development - even other builds - currently using sx110 used s5is s3is s2is .

Logged

hotvedt

106
A540/SX110IS/350D

Re: SX110IS - howto start porting

« Reply #536 on: 21 / April / 2010, 19:59:59 »

Hello, I just got an sx110is and have a question/request:

When i use dcraw on the dng's produced by the camera, i get a quite much bigger image than from acr on the same file, or
from the jpeg.
Would it be possible to change the dng-code so acr doesn't crop this much? I think a little more than 1 megapixel is being cropped away.
Or is it a good reason for cropping this much?

Logged

whoever

280
IXUS950

Re: SX110IS - howto start porting

« Reply #537 on: 22 / April / 2010, 03:59:10 »

Try Thomas Knoll's utility DNG Recover Edges. It is supposed to reset DefaultCropOrigin and DefaultCropSize tags in the DNG header to match the whole active area of the sensor.

Logged