Hi, I am using Ultra Intervalometer on SX10 fw 1.02b (beta CHDK). After running UI successfully and shutting down the camera, I cannot start up the camera with CHDK set to boot (camera starts, CHDK loads and simply camera turns off). Same thing when trying to start CHDK with firmware update.
If I delete the file CHDK\DATA\ULT_IN~1_0 and ULT_IN~1.cfg the camera and CHDK start up just fine.
Content of the ULT_IN~1_0 file (file does not have extension):
@param a Delay 1st Shot (Mins)
@default a 0
@param b Delay 1st Shot (Secs)
@default b 5
@param c Number of Shots
@default c 2
@param d Interval (Minutes)
@default d 0
@param e Interval (Seconds)
@default e 0
@param f Interval (10th Seconds)
@default f 5
@param g Endless? No=0 Yes=1
@default g 0
And my SD card is partitioned, firts part. FAT16, 24 MB with CHDK dir and bin and fi2 file, second part. FAT32, 15 GB, FAT32 with the CHDK directory and the scripts (this is where the above param files are located).
Could this be the problem? The CCHDK.CFG file is also saved on this partition and I dont need to delete that to start CHDK again
Thank you.
