loaded script - cant find how to unload it - Hello, I'm a NEWBIE - HELP!! (Newbies assistance, User Guides and thank you notes) - CHDK Forum supplierdeeply
« previous next »
Pages: [1]   Go Down

loaded script - cant find how to unload it

  • 3 Replies
  • 4844 Views
*

Offline mvt

  • *
  • 2
loaded script - cant find how to unload it
« on: 14 / November / 2009, 11:01:06 »
Advertisements
I am a new user.  I tried the example countdown script to see what it did.  Sounded pretty safe.  But now every time I turn on the camera and enable CHDK, the script is still loaded (or re-loaded).

How do I unload a script?  Can't find any hint in the manual.

Thanks.
Logged
*

Offline Jucifer

  • *****
  • 251
  • [A710IS]
Re: loaded script - cant find how to unload it
« Reply #1 on: 14 / November / 2009, 11:08:38 »
Logged
*

Offline mvt

  • *
  • 2
Re: loaded script - cant find how to unload it
« Reply #2 on: 14 / November / 2009, 17:44:18 »
Thanks for the link.

For completeness here is what I did.

There is no way to just unload a script.  So instead, I just made a new script following the example in one of the referenced posts.  I called it No_Op to indicate "No Operation".  That's a slight misnomer, because it takes a picture (probably what was intended) and leaves <ALT> mode.

I just made a new text file named No_Op.bas in the same directory as default.bas with these lines.

@title No_Op.bas
shoot
exit_alt
end


worked great.
Logged
*

Offline fe50

  • ******
  • 3152
  • IXUS50 & 860, SX10 Star WARs-Star RAWs
    • fe50
Re: loaded script - cant find how to unload it
« Reply #3 on: 15 / November / 2009, 15:49:55 »
@mvt

There's a dummy script file you could load: Default.bas - it's the "default" script which is selected on a fresh CHDK installation, located in the CHDK\scripts folder...

But - there's no need to "unload" a script; in the CHDK config file the last used/loaded script ist stored, just for convenience, to run a script again without loading it again.
In <Alt> the one & only function of the shutter button is to start a script...

There's only one case where "unloading" (or a dummy script) could be reasonable: to prevent the accidentally start of a script.
For this you can use a script with just one single line:

exit_alt
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics
SimplePortal 2.3.6 © 2008-2014, SimplePortal