Locking volume (A570) - Feature Requests - CHDK Forum  

Locking volume (A570)

  • 2 Replies
  • 1823 Views
Locking volume (A570)
« on: 04 / August / 2010, 15:18:39 »
Advertisements
Would it be possible to lock the volume in video mode to "current level"? I have noticed that when recording a music performance and the audience clapping in pace, the camera quickly turns down the volume at each clap, after which it slowly rises again (likely following a PID algorithm). This of course messes up the entire recording...

*

Offline reyalp

  • ******
  • 13391
Re: Locking volume (A570)
« Reply #1 on: 04 / August / 2010, 19:28:52 »
CHDK can't currently control this, but it might be possible.

Certainly would be useful. AGC is the bane of anyone trying to record almost anything with cheap consumer devices :(
Don't forget what the H stands for.

*

Offline fudgey

  • *****
  • 1705
  • a570is
Re: Locking volume (A570)
« Reply #2 on: 07 / August / 2010, 08:54:23 »
I think I once looked into this a tiny little bit (for my a570is) and didn't find an obvious way. But that was a long time ago, we might know more now. Anyway, Canon uses/has used several different audio chips, each having different features and different control logic. This means that learning how to disable AGC on one camera probably only helps a couple of other models with similar audio features that were in production that year.

Anyway, the a570is firmware has a string 'AudioIC_LA74310LP.c' implying that its audio chip could be the Sanyo LA74310LP 'Audio Interface for DSC + Video Driver'. This chip has a built-in AGC (ALC) feature for audio input. The datasheet I have isn't really verbose on these things (or anything else for that matter), but it does show a startup logic control example which at one point enables the ALC. But I'm afraid it probably enables the ALC amplifier which is always in the signal path, and disabling it would mute the mic input.

Another way to disabled AGC would be to take the camera apart and alter the audio circuit e.g. by doing something evil to pin 6 which is the ALC detection pin. That wouldn't give you manual gain control, though, just fixed gain that's probably no good for all purposes.


 

Related Topics