Software control of LCD vs. Video Out - page 2 - General Discussion and Assistance - CHDK Forum

Software control of LCD vs. Video Out

  • 10 Replies
  • 6508 Views
*

Offline achillies

  • ***
  • 227
  • SX130IS
Re: Software control of LCD vs. Video Out
« Reply #10 on: 14 / May / 2011, 18:45:58 »
Advertisements
This is hardware rather than software related, but with the SX130IS, and possibly other cameras that use the AVC DC400 cable, Pin 6 is definately video out enable.  I built a switch between Pin 6 and ground, and when pin 6 is grounded, camera display is output via the cable.  If Pin 6 is open, the camera display stays on the LCD. 

I was hoping for simultaneous output (like PhyrePhox was), but that was not the case.

I'm still trying though.
Don't let the sands of time get in your lunch.

 

Related Topics