Another feature: USB cable remote control - I cannot get this work. I am not sure my cable is OK, because I have nothing else to test with. (I built the cable seen in the Wiki, with CR2032 battery + switch)
I am considering changing the alt shortcut to the "play" button. This would mean a short press on play would open the alt menu, while a long press would have the normal firmware behavior. We discussed standardizing on this earlier for cameras without a print. edit:After using it with play as the alt button, I definitely think that is better than a combo.
In release 1760: "Make card bootable.." turns off the camera, so I cannot try the new changes.
BTW, do I need to start over the whole installation from "low level format" and everything every time? I cannot see the "how to update your install" in the Wiki. http://chdk.wikia.com/wiki/Bootable_SD_card So I started over from point 1, but now it cannot be finished.
Last remaining issue for me for now is USB remote. Any ideas for that? Connecting to PC-USB makes it "half-press", so I think CHDK is OK (it does not shot the picture this way, is that OK?).
But I cannot get this with the CR2032 battery based cable. I might have mixed up some cables when wiring, but it's unlikely. Did anybody try it according to http://chdk.wikia.com/wiki/USB_Remote_Cable ?
You might need to go to a different battery stack up to get closer to 5V
Why do I need to press the power button so long to turn on?
Started by pizzicat Firmware Dumping
Started by hiker_jon General Discussion and Assistance
Started by slyth999 General Discussion and Assistance
Started by gtoonstra « 1 2 ... 5 6 » General Discussion and Assistance
Started by rdx1968 General Help and Assistance on using CHDK stable releases