Canon blocked high ISO on log exposures for the SX40HC - Feature Requests - CHDK Forum supplierdeeply
« previous next »
Pages: [1]   Go Down

Canon blocked high ISO on log exposures for the SX40HC

  • 1 Replies
  • 3255 Views
*

Offline tcollin

  • *
  • 17
  • SX30IS - A590IS - ELPH300HS - SX260HS
Canon blocked high ISO on log exposures for the SX40HC
« on: 06 / December / 2011, 23:52:45 »
Advertisements
If you use a slower speed than 1.3 sec the ISO is blocked at 100. It is written in the Canon manual. This limitation is new. The SX30 was able to use any ISO on long exposures. Will CHDK be able to correct this new limitation?

The page from the SX40HC manual (in french)
Logged
*

Offline outslider

  • *****
  • 762
Re: Canon blocked high ISO on log exposures for the SX40HC
« Reply #1 on: 07 / December / 2011, 18:43:03 »
ISO override is a little bit different in its effects than AV or TV. Since CHDK allows you to override TV to be shorter or longer than Canon firmware allows you and AV to be (in general) higher, the ISO is rather not possible to be overriden beyond Canon firmware highest or lowest berrier.

Nevertheless in this case, since at 1.3 s the Canon firmware block ISO at 100, which is not the lowes or the highest possible ISO at all on this camera we can believe that you can override it.

The only way to be sure of that is just to try;) So take a few shoots with and without different overriden ISO values and check wheter overrides make any change to the picture in brightness and noise. I'm pretty sure, that this will work!
Logged
if (2*b || !2*b) {
    cout<<question
}

Compile error: poor Yorick
Pages: [1]   Go Up
« previous next »
 

Related Topics