Battery Status stuck in 100% - General Discussion and Assistance - CHDK Forum
« previous next »
Pages: [1]   Go Down

Battery Status stuck in 100%

  • 3 Replies
  • 2568 Views
*

Offline wearver

  • *
  • 2
Battery Status stuck in 100%
« on: 14 / December / 2011, 04:41:35 »
Advertisements
Hi guys, i change my CHDK firmware to a new one and now the Battery status dont show the real status. I have 2 deferents cameras SD1000 and S5, in the SD1000 i set the high mV to 750 same to the baterry and low to 150mV. Doing this dont change the status, is show 100%, i change to 400mV and 50mV and the status maintain in 100%. The voltage show the real status, but the icon show fully charge.

In the S5 i have the same insures 
Logged
*

Offline Pauls9

  • **
  • 60
  • S3 IS
Re: Battery Status stuck in 100%
« Reply #1 on: 14 / December / 2011, 04:50:17 »
Are you sure the SD1000 battery is 0.75 volts fully charged? Should this be 7500 mV perhaps?
Logged
*

Offline wearver

  • *
  • 2
Re: Battery Status stuck in 100%
« Reply #2 on: 14 / December / 2011, 05:03:52 »
Quote from: Pauls9 on 14 / December / 2011, 04:50:17
Are you sure the SD1000 battery is 0.75 volts fully charged? Should this be 7500 mV perhaps?

Tks man. I set wrong value.  The S5 use 4x1.2v, how mV i set?
Logged
*

Offline Pauls9

  • **
  • 60
  • S3 IS
Re: Battery Status stuck in 100%
« Reply #3 on: 14 / December / 2011, 06:46:54 »
1v = 1000 mV (millivolts)

So 4x1.2V = 4800 mV
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics


SimplePortal © 2008-2014, SimplePortal