so... am I correct in thinking that the port is working, at least to some extent?
I grabbed the latest build from http://mighty-hoernsche.de/trunk/
(sx260hs-101a-1.2.0-2225-full_ALPHA) and followed the instructions here:http://chdk.wikia.com/wiki/Prepare_your_SD_card
but I can't seem to get the splash screen to appear - any hints or pointers to tricks I should know about?
I did the low-level format of the SD card (16 GB), confirmed it was FAT32, copied the files over, and tried the "Firmware Update Method" described on the above page
but after doing "Firmware Update..." and confirming, screen just goes black, and it's dead until I take out the battery and re-start
I must admit I'm a little confused about what should be in the vers.req file - leave it empty? put in the Canon firmware version (1.00 rev 2.00)? something else?
anyway, thx in advance, apologies if this is premature or I'm doing something stupid