Need Help with S100 Motion Detector Script - General Discussion and Assistance - CHDK Forum
« previous next »
Pages: [1]   Go Down

Need Help with S100 Motion Detector Script

  • 2 Replies
  • 3876 Views
*

Offline pdw911

  • *
  • 14
Need Help with S100 Motion Detector Script
« on: 07 / August / 2012, 16:34:15 »
Advertisements
I am using firmware "B", build 2057. I have the basics of CHDK pretty well down and started to play with the motion script

When I set the camera to manual, manual focus, no focus light etc and run the script...it continually sequentially shoots, regardless of motion, until I end script from running

Do I need to adjust settings in the script??....there doesn't seem to be much documenation on how to use it (tons, however, on the script itselfand how it was written but it was unclear on when and how to make changes)

Any advise greatly appreciated
Logged
*

Offline waterwingz

  • ******
  • 12140
    • Waterwingz
Re: Need Help with S100 Motion Detector Script
« Reply #1 on: 07 / August / 2012, 16:41:04 »
You most likely need to adjust some of the parameters sent to the motion detection script command.  Which ones might depend on which of the 100's of MD scripts available.

This should help with the documentation issue : CHDK Wiki Motion Detection Page

Also,  you might want to take a look at this : http://chdk.setepontos.com/index.php?topic=7887.msg85940#msg85940

BTW : the porting threads for each camera are usually a better place to ask questions about specific cameras rather than starting a new thread.
« Last Edit: 07 / August / 2012, 16:44:12 by waterwingz »
Logged
Ported :   A1200    SD940   G10    Powershot N    G16
*

Offline pdw911

  • *
  • 14
Re: Need Help with S100 Motion Detector Script
« Reply #2 on: 08 / August / 2012, 07:48:41 »
Thanks...I'll experiment with script settings
Logged
Pages: [1]   Go Up
« previous next »
 

Related Topics


SimplePortal © 2008-2014, SimplePortal