chdkptp with the SX40HS-100i - General Discussion and Assistance - CHDK Forum

chdkptp with the SX40HS-100i

  • 2 Replies
  • 2638 Views
*

Offline dvip

  • ****
  • 451
chdkptp with the SX40HS-100i
« on: 31 / December / 2012, 11:08:13 »
Advertisements
I can run chdkptp.exe (r11) on Windows 7/64-bit with my A590IS-101b without problems.
But when I run chdkptp.exe with the SX40HS-100i (in play mode) and hit "Connect" I get "error: no devices available".

However, the camera does shows in Explorer as:

Portable Devices(1)
"Canon PowerShot SX40 HS"
Digital Camera

and I can access files and folders from Explorer without problems.

I'm using philmoz-reorg@2433 on both cameras.
 
Do I need anything else to make chdkptp.exe connect to the SX40HS?


*

Online reyalp

  • ******
  • 14126
Re: chdkptp with the SX40HS-100i
« Reply #1 on: 31 / December / 2012, 14:54:35 »
If you see it in explorer, then the libusb driver probably isn't correctly installed. On win7 (vista and later I think) you should use the INF driver rather than the filter driver.

In some cases (I'm not exactly clear on the details) the libusb driver only associates with the device on a particular port, so if you plug it into a different one than where the camera was when you crated the INF, it will show up in windows rather than libusb.

edit:
to be clear, you need to install and INF driver for each camera you use.
Don't forget what the H stands for.

*

Offline dvip

  • ****
  • 451
Re: chdkptp with the SX40HS-100i
« Reply #2 on: 31 / December / 2012, 16:30:33 »
>edit:
>to be clear, you need to install and INF driver for each camera
>you use.

This did it. Problem fixed. Thanks reyalp!


 

Related Topics


SimplePortal © 2008-2014, SimplePortal