Aperture 2.7 override at full zoom - canon sx40 - General Help and Assistance on using CHDK stable releases

schnur07

Aperture 2.7 override at full zoom - canon sx40

« on: 17 / January / 2013, 23:13:54 »

Advertisements

Will the aperture 2.7 override work at full zoom? I've tried it here inside the house real quick and am not seeing a noticeable difference when I hold the shutter speed constant. I definitely see differences at the upper end of the aperture. I stopped seeing difference at apertures below around f/5 or so.

Logged

philmoz

3332

Re: Aperture 2.7 override at full zoom - canon sx40

« Reply #1 on: 18 / January / 2013, 00:12:57 »

Quote from: schnur07 on 17 / January / 2013, 23:13:54

Will the aperture 2.7 override work at full zoom? I've tried it here inside the house real quick and am not seeing a noticeable difference when I hold the shutter speed constant. I definitely see differences at the upper end of the aperture. I stopped seeing difference at apertures below around f/5 or so.

No - maximum aperture is f/5.8 at 150.5mm zoom.

Phil.

Logged

CHDK ports:
sx30is (1.00c, 1.00h, 1.00l, 1.00n & 1.00p)
g12 (1.00c, 1.00e, 1.00f & 1.00g)
sx130is (1.01d & 1.01f)
ixus310hs (1.00a & 1.01a)
sx40hs (1.00d, 1.00g & 1.00i)
g1x (1.00e, 1.00f & 1.00g)
g5x (1.00c, 1.01a, 1.01b)
g7x2 (1.01a, 1.01b, 1.10b)

schnur07

Re: Aperture 2.7 override at full zoom - canon sx40

« Reply #2 on: 18 / January / 2013, 02:22:32 »

Thanks again Phil. So what's the point of the override on the lower aperture if it can't go beyond the range of the original firmware? I must be missing something.

Logged

Microfunguy

4037

Re: Aperture 2.7 override at full zoom - canon sx40

« Reply #3 on: 18 / January / 2013, 06:09:58 »

Quote from: schnur07 on 18 / January / 2013, 02:22:32

So what's the point of the override on the lower aperture if it can't go beyond the range of the original firmware? I must be missing something.

Well, it would complicate the code.
Some cameras have over 100 hundred aperture values that change as you zoom.

CHDK would need to know all those values and dynamically force the menu to only allow higher values at a particular zoom setting.

Logged