I use the powershot D20 but I dont seem to get the led (green one on top) permanently on, when the lcd is off. The problem arises when the shoot command appears in the script.
When the shoot command is not there, the lcd turns off and then the led stays on till the end of the script. Below the basic script where the led is on while the lcd is off:
sleep(2000)
set_lcd_display(0)
set_led(4,1)
sleep(5000)
set_lcd_display(1)
set_led(4,0)
console_redraw()
This is going fine but when i want to use the shoot command (for implementing it in one of the intervalometers) it is not working. See Below.
sleep(2000)
shoot()
set_lcd_display(0)
set_led(4,1)
sleep(5000)
set_lcd_display(1)
set_led(4,0)
console_redraw()
In this script the lcd is still going on and off. But during lcd off the led is also off. So it seems that the shoot command alters something and overrules bits of the script.
Is there a simple solution for this?
Cheers Aniek